Basic Agriculture Engineering MCQs Quiz Test with Solved Answers.
Basic Agriculture Engineering MCQs with Solved Answers.
#1. When Froude number greater than unit then flow is termed as.
#2. A channel with a longitudinal slope angle, it can be seen that the depth of flow is equal to be depth of flow section divided by
#3. The effect of viscosity relative to inertial can be represented by.
#4. The product of the water area and the two-third power of the hydraulic radius.
#5. The ratio the water area to the top width is called
#6. A covered channel comparatively short length is called
#7. The effect of gravity upon the state of flow is repressed by the ratio of inertial force to the gravity forces this ratio is termed as.
#8. If the viscous forces are so strong relative to inertial force than flow will be.
#9. The depth of flow remains constant during the time interval under consideration this type of flow is called
#10. The product of the water area and the square root of the hydraulic depth is termed as
#11. The hydrostatic law of pressure distribution does not hold strictly for______.
#12. A channel built with unvarying cross section and constant bottom slope is called.
#13. Cross sectional area of the flow normal to the direction of flow is called.
#14. A channel of wood, metal concrete, or masonry, usually supported on or above the surface of the group to carry water across a depression
#15. When water flows in a channel a force is developed that acts in the direction of flow on the channel bed is termed as
#16. If the viscous force is weed relative to the inertial forces, the flow is termed as.
#17. The measured maximum velocity in ordinary channels usually appears to occur below the free surface at a distance of ______ to ________ of the depth
#18. Crossectional areas of the water in the channel divide by the width of free surface is called
#19. When Froude number less than unit then flow termed as.
#20. Where the discharge of a steady flow is non-uniform along the channel this type of flow is called.
#21. In a flow when water fluctuate from time to time while remains parallel to the channel bottom is called
#22. : The value of Bouzinesq coefficient or momentum coefficient for fairly straight prismatic channels varies approximately from _______ to_________.
#23. when Froude number equal to unit the flow is said to be
#24. In open channel flow if depth of flow is same at every section of the channel, the flow is called.
#25. If depth changes abruptly over a comparatively short distance it is termed as
#26. : A long and mild-sloped channel built in the grouped, which may be unlined or lined, is called.
#27. What is the area of the trapezoidal channel
#28. A channel having steep slop called
#29. Coriolis coefficient’s value varies from about to for fairly straights prismatic channels
#30. A comparatively long covered carry water through a hill used to obstruction on the ground.
Basic Agriculture Engineering MCQs Quiz Test 5
Related
1 thought on “Agriculture Engineering MCQs Quiz Test 6”